This bolt or stud is intended for the engine and application described in the product details. Check fitment, thread and dimensions before installation.
Product information
Material: CA625+
Part Number: 201-6002
Application: BMW 5.0L (S85) V10
Cap Screw without Washer - Rod Bolt Installation
\[1\] Please check the part-number(s) for your application
against the part-number(s) listed on the instruction sheet.
\[2\] Make sure there is an adequate chamfer around the bolt
hole on the connecting rod cap to clear the radius under
the head of the bolt.
\[3\] Lubricate the threads and the under head of the bolt with
ARP Ultra-Torque Fastener Assembly Lubricant.
\[4\] ARP recommends using the STRETCH METHOD when
tightening rod bolts. Following the instructions for using a
stretch gauge, Stretch the bolts to
. 0075” - .0080”
\[5\] If you do not have a stretch gauge, torque the bolts to
60 ft-lbs
\[6\] The connecting rods should always be re-sized after new
rod bolts are installed.
\[7\] A log should be kept on the original non-torqued length
of each bolt. Bolts that have any permanent deformation
or have increased in non-torqued length by more than
.001 in. should be replaced.
Specifications
Vehicle make: BMW
Engine code: S85
Stuck? Our experts will get you back on track!
With years of industry experience, we're here to answer your questions.
Contact us
